240Z: Turn signal switch refurbish & assembly

Since there is no out-of the box solution and not a single internet-thread on this topic i had a hard time completing this step and therefore the lack of updates. It seems just a turn signal switch assembly, but i spent several hours on this one to finally get a clean and well working result. And had to buy several stuff while doing it so that allways gave me a little break inbetween. Anyhow here is how i went:
After four attempts i managed to remove one of the four plastic handles (the last one) which i had without braking it – success!!

Cleaned the switching lever with some scotch and brite pads and you can see the copper where the corrosion started:

Painted it with some gloss black rattle-can spray:

But was disapointed by the result, so i removed the paint and sprayed it again:

This time the result was much better. Time to assemble things again:

Wire and positive pole back in:

Bought this plastic polishing / Scratch remover stuff and cleaned the plastic knob:

Not perfect but much better than before:

Wasn’t able to find anything near the original brass thinky to mount the handle back into the base so i got a little inventive and used brass nails istead. Looks like OEM, fits perfect and is more stable than the original design:

And than the rest of the parts came back together:       

Final result. only need to connect the wires back together. but otherwise super happy with the result: